Electrocompaniet AW250R - Manual (Page 3)

Unpacking the amplifier:
Immediately upon receipt of the amplifier, inspect the carton for possible damage during
shipment. If the carton is visibly damaged, a claim must be filed with the carrier as soon as
possible.
Unpack the unit carefully, and please do remember to save all packaging materials for
future shipment. The carton and packaging have been designed to offer the safest possible
protection when transporting your amplifier.
The content of the carton is as follows:
1 pcs Electrocompaniet Ampliwire 250 DMB-R
1 pcs AC power cord
1 Owner
's Manual
1 pcs Spare fuse, 10.0 AT slow-blow 5x20mm (120V AC)
5.0 AT slow-blow 5x20mm (240V AC)
The actual spare fuse is located inside the AC 3 pin receptacle.
Connecting the AW 250 DMB-R
Connecting to mains
Check that the mains voltage printed on the rear panel of the amplifier corresponds with
the line voltage in the territory were you intend to use your amplifier.
How to avoid damages
A good operating practice is to turn off all equipment before any connections or
disconnection’s are made. Do not under any circumstances connect or disconnect
equipment when power is turned on. If you insist on connecting or disconnecting while
power is turned on, you should be aware that the design of the RCA plug generates a
large transient when inserting the plug. This could damage both the speakers and the
amplifier.
The rear panel
The rear panel of the Ampliwire AW 250 DMB is equipped with two sets of RCA input
sockets, marked + and -, and one XLR female socket, for each channel.
Single-ended (RCA) input and operation
Upon arrival, the amplifier is set for single-ended use with a shorting plug in the negative
RCA input.This will short the negative (-) input of the amplifier to ground. With shorting
plugs in position, the amplifier is ready to be connected in a normal way with a single
ended preamplifier.