Easyrig Changing the Turtle X spring balancer - Manual (Page 2)

1. Remove the adjustment wheel with a screwdriver. 2. Pull the cloth over the adjustment spring.
3. Hold on to the hex-headed screw inside the
back pack.
4. And remove the M6 x 40 mm hex headed screw.
5. Fold up the velcro tape and open the zipper. 6. Remove the hex-headed screws, one key inside
the back pack.
Now the support arm is free from the back pack
and you can remove it.
7. Remove the plastic cover on the camera hook
and open the knob.
8.Remove the spring balancer by opening the
M4 x 35 mm screw.
9. Put the new feather package in position. 10. Inside the spring balancer is a loose wheel. It’s
important to have it in correct position. By using
the hexagon you can keep the wheel in position.
11. Mount the M4 x 35 screw. When the screw is
through the nut it’s perfect, otherwise the cover can
bend.
12. Mount the line through the arm by using the
spring cord tool.
13. Mount the line through the bend arm over
the wheels.
14. Mount the line through the adjustment block.