EarthQuake 6065VEC - Manual (Page 15)

OPERATOR INSTRUCTIONS ANd PARTS
CRT Models 5055C & 6065VEC
Page 15
GetEarthquake.com
800-345-6007
BELT REPLACEMENT PART #’S:
727A (forward)
730 (reverse)
ChANGE FORWARd/REvERSE BELT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Remove belt guard.
• Remove the forward belt from the forward engine pulley:
- Gently pull the engine recoil rope to rotate the pulley.
- With the pulley turning, force the forward belt out of the
V-groove.
- Slide the belt free of the engine pulley.
- Pull the forward belt down and out of the way.
• Remove the reverse belt from the reverse engine pulley:
- Gently pull the engine recoil rope to rotate the pulley.
- With the pulley turning, force the reverse belt out of the
V-groove.
- Slide the belt free of engine pulleys and reverse belt
guides.
- Pull belt down and away from transmission pulley.
• Install new reverse belt:
NOTE: V side of belt should be up, away from pulley.
- Thread belt up from bottom.
- Place belt around transmission pulley in groove.
- Place belt under reverse belt guides.
- Gently pull engine recoil rope while forcing the belt over the
edge of the engine pulley into the V-groove.
• Install new forward belt:
- Place forward belt in transmission pulley groove.
- Gently pull the engine recoil rope to rotate the pulley while
forcing the forward belt into the V-groove.
4. Replace belt guard.
5. Attach spark plug wire.
Reverse Belt,
V side up
TRANSMISSION
PULLEY
Forward Belt
ENGINE PULLEY
dO NOT OPERATE TILLER BEFORE REAdING
ThE ENGINE MANUAL PROvIdEd IN ThE PARTS
PACkET.
CAUTION !
TEMPERATURE OF MUFFLER ANd NEAR BY AREAS
MAY ExCEEd 150° F. AvOId ThESE AREAS.
WARNING !
IMPORTANT
ENGINE CAN OvERhEAT ANd BECOME dAMAGEd
IF dEBRIS BLOCkS ThE COOLING SYSTEM OR
ROTATING SCREEN.
NEvER RUN ENGINE WIThOUT COMPLETE AIR
CLEANER INSTALLEd ON ENGINE.