EarthQuake E43 - Manual (Page 6)

Page 6 ARDISAM
.com .com
1-800-345-6007
Mixing F Mixing F Mixing F Mixing F Mixing Fuel and Filling F uel and Filling F uel and Filling F uel and Filling F uel and Filling Fuel T uel T uel T uel T uel Tank ank ank ank ank
Mixing Fuel
1. Fuel must be mixed in a container outside in a well
ventilated area.
2. Fill certified fuel container 1/4 full of recommended
fuel.
3. Add recommended amount of 2-cycle oil. DO NOT
use 2-cycle marine oil.
4. Screw container cap on straight and tight.
5. Shake the container to mix fuel and oil.
6. Unscrew cap slowly to vent. Add the remainder of
fuel requirements.
7. Wipe away any spilled fuel or oil and allow to
evaporate before moving or transporting.
Avoid injury! Never store engine with fuel in the
tank indoors. Fuel and fuel vapors are highly
flammable.
CAUTION
Avoid injury! Never mix fuel and oil directly in
engine fuel tank. Use only non-metal, portable fuel
containers approved by the Underwriter’s
Laboratory (U.L.) or the American Society for
Testing & Materials (ASTM).
CAUTION
Avoid injury! An adult must always handle and fill
the engine with fuel.
CAUTION
Avoid injury! Always handle gas in a well ventilated
area, outdoors, away from flames or sparks.
CAUTION
This engine uses a gas/oil mixture. DO NOT run on
straight gas only, engine damage will result.
Filling Fuel Tank
1. Shut-off engine and allow engine to completely cool
before refilling the fuel tank.
2. Move to a well ventilated area, outdoors, away from
flames and sparks.
3. Clean debris from area around the fuel cap.
4. Loosen fuel cap slowly. Place the cap on a clean, dry
surface.
5. Carefully add fuel without spilling.
6. Do not fill gas tank completely full, allow space for
fuel to expand.
7. Immediately replace fuel cap and tighten. Wipe off
spilled fuel and allow to dry before starting engine.
Assembly Assembly Assembly Assembly Assembly
To attach auger to powerhead, align hole at the top of the
auger shaft with the output shaft hole. Insert bolt and
secure bolt with provided nut or allen wrench depending
on size of auger.
NOTE: The ends of the bolt should be flush with
auger collar. Bolt head and thread end should never
go beyond earth collar.
Starting and Stopping Engine Starting and Stopping Engine Starting and Stopping Engine Starting and Stopping Engine Starting and Stopping Engine
1. Move engine to a well ventilated area, outdoors, to
prevent carbon monoxide poisoning.
2. Move to an area away from flames or sparks, to avoid
ignition of vapors if present.
3. Remove all debris from air cleaner holes and fuel cap
to ensure proper air flow.
4. Turn switch to the ON position.
5. Priming:
•
When using the primer bulb, allow the bulb to return
completely to its original position between pushes.
•
Choke must be in the OFF or RUN position when
pushing or using the primer bulb.
Avoid injury! DO NOT start engine if fuel is spilled.
Wipe off excess fuel and allow to dry. Remove
engine from area to avoid sparks.
CAUTION
OPERA OPERA OPERA OPERA OPERATION TION TION TION TION