beautypg.com

Important, Danger, Warning – EarthQuake 9070300 User Manual

Page 4

background image

Operator’s Manual

Chipper Shredders

4

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5

TRAINING

1. Read the operating and service instructions carefully. Be

thoroughly familiar with the controls and the proper use of

the equipment. Know how to stop the unit and disengage

the control quickly.

2. Keep the area of operation clear of all persons, particularly

small children, and pets.

GENERAL OPERATION

1. Read, understand, and follow all instructions in the manual

and on the unit before starting.

2. Do not put hands or feet near rotating parts or under the

machine. Keep clear of the discharge opening at all times.

3. Only allow responsible adults, who are familiar with the

instructions, to operate the unit (local regulations can

restrict operator age).

4. Be sure the area is clear of other people before operating.

Stop the unit if anyone enters the area.

5. Never direct discharge material toward anyone. Avoid

discharging material against a wall or obstruction.

Material may ricochet back toward the operator.

6. Operate the machine only in daylight or good artificial

light.

7. Do not operate the unit while under the influence of

alcohol or drugs.

8. Always wear eye and hearing protection when operating

this unit.

9. Keep in mind the operator is responsible for accidents

occurring to other people or property.

10. It is a violation of California Public Resource Code Section

4442 to use or operate the engine on or near any forest-

covered, brush-covered, or grass-covered land unless the

exhaust system is equipped with a spark arrester meeting

any applicable local or state laws. Other states or federal

areas may have similar laws.

11. Always operate the chipper shredder outdoors, on a firm,

level, earthen or grassy surface where the unit will be

stable and stay in position. Never attempt to operate

the unit on a slope, or on a wet or slippery surface where

you could slip and fall toward the chipper cone or hopper

openings.

12. Never operate the chipper shredder on asphalt, concrete,

or other hard surfaces as material being ejected out of the

discharge chute could ricochet, causing injury to you or

bystanders.

13. Always obey the size limitations for tree limbs and

branches stated in the Waste Materials Guide portion of

this manual.

14. Never leave the machine running unattended. Always turn

off the engine, wait for the rotor to come to a complete

stop, and disconnect the spark plug before leaving the

area. Always move the unit to a safe storage area when not

in use.

15. Always maintain secure footing and solid balance while

starting or operating the chipper shredder. Never lean

directly over the machine.

16. Always stand to the side of the chipper cone when feeding

tree limbs and branches into the unit, as tree limbs,

branches, and harder woods may kick back while being

chipped.

17. Always keep hands out of the chipper cone and shredder

hopper when feeding materials. Never wrap fingers tightly

around branches as you are feeding them into the unit,

as a sudden inward surge could pull your hands and arms

into the unit.

18. Never allow material to build up in the discharge area or

shredding chamber, as this may cause new material being

fed into the machine to kickback with sufficient force to

injure you or other bystanders.

19. Never allow material to build up around the engine during

chipper shredder operation. This could result in a fire, or

overheating of the engine.

20. Never attempt to reposition or move the chipper shredder

unit while it is running. Doing so could cause the machine

to tip over, and reaching to steady the unit could result in

accidental insertion of your hands into the chipper cone or

shredder hopper areas.

IMPORTANT

THE RIGHT AND LEFT SIDES OF YOUR CHIPPER

SHREDDER ARE DETERMINED FROM THE OPERATING

POSITION, STANDING AND FACING THE UNIT.
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU

MUST ADD ENGINE OIL BEFORE STARTING ENGINE.

DANGER

THE CHIPPER SHREDDER HAS SPINNING BLADES

THAT CAN AMPUTATE HANDS AND FEET. DO NOT

PLACE HANDS OR FEET IN THE HOPPER OR CHIPPER

CONE, OR DISCHARGE CHUTE.

WARNING

THIS UNIT DISCHARGES DEBRIS AT HIGH SPEEDS.

ALWAYS WEAR PROTECTIVE GOGGLES AND DO NOT

OPERATE WITHOUT THE DEBRIS BAG IN PLACE.
DO NOT ALLOW ANYONE IN THE AREA WHILE THE

UNIT IS RUNNING. IF SOMEONE DOES ENTER THE

AREA, SHUT THE UNIT OFF IMMEDIATELY UNTIL

THEY LEAVE. ORGANIZE THE WORK AREA PRIOR TO

STARTING WORK.

This manual is related to the following products: