Dv Mark DV AC101 - Manual (Page 5)

5
14) CH2 LOW This knob controls the amount of low frequencies in your sound, boosts or cuts the level of the frequencies around 60 Hz
(± 16 dB).
15) CH2 HIGH This knob controls the level of mid frequencies, boosts or cuts the level of the frequencies around 5 kHz (± 16 dB).
16) VPF The VPF (Variable Preshape Filter) knob boosts lows and highs, and cuts mids around 380 Hz. It’s very effective for strumming and
finger picking tecniques, and/or to cut mid and enhance low and high to the voice tone using a microphone connected to the XLR input of CH2.
17) CH2 EFFECT MIX Controls the amount of effect in the channel 2.
18) LINE OUT This knob controls the level of the signal from the XLR LINE OUT (29) to the mixing console in live or studio applications.
19) MASTER This control is the master feed from the end of the two preamp channels to the power stage section.
20) MIX CLIP LED If the MIX CLIP light to turn on at all, you’d turn down the EFFECT MIX level control to set the optimal effect level avoiding
its clip
21) MAIN ON/OFF SWITCH This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power
plug must be connected to avoid any injury to the user or damage to the unit.
DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset to that country’s
voltage. So make sure you’re sending the correct voltage to your amp before you connect it to AC power
22) ON LED A blue indicator LED is illuminated whenever the main on/off switch (19) is on and the amplifier is receiving power
A
H
2
5
0
A
H
2
5
0
A
H
2
5
0
INPUT
INPUT
LOW MID HIGH EFFECT MIX
Min Max
GAIN
Min Max
GAIN PULL FOR
PHANTOM
-16 +16 -16 +16 -16 +16
ANTIFEEDBACK
LOW
CLIP
CLIP MIX CLIP
HIGH EFFECT MIX
-16 +16 -16 +16 Off Max Off Max
Off Max Off Max
VPF
0°
PHASE
180°
Chorus 1
Revb 2
Revb 3
Revb 4
Chorus 2
Revb1
ON
OFF
TUNER OUT RETURN EFFECT SEND EFFECT
GND LIFT POST EQ
PRE EQ
LINE OUT
BALANCED:
PIN1: GROUND
PIN2: SIGNAL +
PIN3: SIGNAL
SPEAKER OUT
CLASS 2 WIRING
1 + = SIGNAL
1 = GND
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
AVIS:
RISQUE DE CHOC
ELECTRIQUE
NE PAS OUVRIR.
CAUTION:
RISK OF ELECTRIC
SHOCK DO NOT OPEN.
CAUTION:
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE
REPLACE ONLY WITH SAME
TYPE AND RATING FUSE.
ATTENTION:
REMPLACER UNIQUEMENT PAR
UN FUSIBLE DE MEME TYPE.
15
1 2 3 4 5
24
8 9
25
27 28 26
6 7
30 29
31
10
11 12 13 14 16 17 18 19 20
23
21
22