Rear panel – Dv Mark DV JAZZ 12 User Manual
Page 5
5
8) AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user
or damage to the unit.
DV Mark amps and combos are manufactured to be used in the country where they have been sold, and are factory preset to that country’s voltage.
So make sure you’re sending the correct voltage to your amp before you connect it
to AC power.
9) ON/OFF SWITCH This switch delivers AC power to the amp,
10) LINE OUT This balanced XLR output sends a balanced signal to the mixing
console or snake in live and studio situations. The Line Out signal is post-EQ and
post-reverb.
11) GROUND LIFT Occasionally, when you’re playing live and using the Line Out
(10), the soundman will detect a hum from your amp’s signal. This is often due to
a ground problem related to your power source; You will likely eliminate this hum
simply flipping the Ground Lift switch.
12) INTERNAL SPEAKER ON/OFF This switch turns off the speaker when using
headphones so you can practice anywhere and anytime you like.
13) SPEAKER OUT Use this output to connect an 8 ohm extension cabinet, giving you a louder rig.
14) PHONES For quiet practing plug headphones into this mini plug 1/8” input, turning OFF the internal speaker switch (12).
REAR PANEL
ON
INPUT
AUX
DV LITTLE JAZZ
0
MAX
0
MAX
SPEAKER OUT
MINIMUM
LOAD 8 Ω
INTERNAL
SPEAKER
LINE OUT
ON
OFF
GND
LIFT
ON
OF
F
PHONES
1
2
3
4
5
6
7
10
8
9
11
12
13
14