Installation and connections, Connecting your dvd player with component output – Dukane 8070 User Manual
Page 28
20
AUDIO IN
L
R
AUDIO OUT
L
R
Component
Y
C
b
C
r
AC IN
AUDIO OUT
MONITOR OUT
PC CONTROL
AUDIO
S-VIDEO IN
COMPUTER 2 IN
VIDEO IN
COMPUTER 1 IN
AUDIO
L/MONO
R
AUDIO
L/MONO
R
COMPUTER 1 IN
AUDIO
2. Installation and Connections
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
Connecting Your DVD Player with Component Output
DVD player
Audio Equipment
Audio cable (not supplied)
Optional 15p - to - RCA (female)
ן3
cable (ADP-CV1)
Component video RCA
ן3
cable (not supplied)
You can connect your projector to a DVD player with component output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable
(RCA
ן3) and the optional 15-pin-to-RCA (female)ן3 cable to connect your DVD player to the COMPUTER IN
connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a
composite VIDEO output of the DVD player to the Video Input of the projector.
3. Connect the supplied power cable. See page
22
.
4. Turn on the projector and DVD player.
A component signal will be automatically displayed. If not, from the menu, select [Advanced]
→ [Signal Select] →
[Computer], and then place a check mark in the Component radio button.