DeLonghi Pinguino PAC 250 U User Manual

Page 8

TEMPORARY INSTALLATION

Note:

In both cases (permanent and temporary installations) make sure that the Pinguino is positio-
ned on level ground. If necessary use the two caster stops for the front casters

This installation makes it easy
to use Pinguino in any room,
provided there is a window or
a door: it allows you to use the
Pinguino immediately.

Suction discs may be used to
keep window or door closed.

Pinguino is equipped with an
adjustable window bracket. If
you have a sash window,
place the bracket on the win-
dow sill, extend the bracket
fully within the window frame
and lower the window onto the
bracket. Insert the nozzle of
the exhaust hose into the slot,
then connect the hose to the
air conditioner.

30 cm

SET UP INSTRUCTION

For permanent installation place the Pinguino near the outlet opening in wall or window (where it is
meant to be used). The diagram below shows the correct way to installl the exhaust hose.

1) Water collects at this point

2) Bend this section

3) Bend this section

YES

ELECTRICAL CONNECTION

Check that the power supply voltage is 115 V ~ 60 Hz.

Important:

if you need to use and extension cord, please be sure to
use a

heavy duty

extension cord (minimum 14 gauge).

Before connecting the Pinguino to power supply, make sure that all
switches on the front control panel are in the OFF position.
Connect power cord found in storage compartment at rear of the
Pinguino.

fig. 5

fig. 6

fig. 7

fig. 8

fig. 9

window
bracket