Deltech Fitness DF404- Hyperextension Bench - Manual (Page 5)

TOOLS REQUIRED:
ADJUSTABLE WRENCHES OR METRIC SOCKET SET
ASSEMBLE THE FRAME (E) TO THE FEET (A) USING THE M12 x 70MM BOLTS (P), M12 WASHERS (R)
AND M12 LOCKNUTS (T). THEN INSTALL THE RUBBER BOOTS (G) ON THE UNIT.
NEXT ATTACH THE SEAT FRAME (C) TO THE FRAME (E) USING THE M12 x 70MM BOLTS (P) AND M12
LOCKNUTS (T).
INSTALL 1-3/4” SQUARE CAP (K) INTO FRAME AND SLIDE LEG HOLD DOWN ASSEMBLY TO DESIRED
POSITION. MAKE SURE PIN ENGAGES ADJUSTMENT HOLE AND TIGHTEN KNOB TO SECURE.
MAKE SURE ALL THE BOLTS ARE TIGHT BEFORE USE. REMEMBER TO CHECK THEM PERIODICALLY
TO MAKE SURE THEY ALWAYS STAY TIGHT.
ADJUSTING THE FOOT REST: RAISE AND LOWER THE FOOT REST USING THE PULL
PIN. MAKE SURE THE PULL PIN IS ENGAGED IN THE ADJUSTMENT HOLE BEFORE USE.
LEG HOLD DOWN
G
G
E
A
A
P
P
P
R
R
R
R
T
T
T
G
G
C
K
R
R