Deltech Fitness DF102- Two In One Flat to Incline Bench - Manual (Page 7)

BOLT THE REAR LEG (D) TO THE BODY USING THE M10 x 75MM BOLTS (K), THE M10 WASHERS
(N) AND M10 LOCKNUTS (M).
BOLT THE FRONT LEG (A) TO THE BODY USING THE M10 x 75MM BOLTS (K), THE M10 WASHERS
(N) AND M10 LOCKNUTS (M). INSERT KNOB (J).
INSTALL THE RUBBER SHOES (G) TO FRONT AND REAR LEGS.
ADJUSTING THE BACK PAD: RAISE AND LOWER THE BACKREST USING THE PULL PIN. TURN
THE KNOB TO LOOSEN FOR ADJUSTMENT MAKE SURE THE PULL PIN IS SECURE IN THE
ADJUSTMENT HOLE THEN TURN THE KNOB TO TIGHTEN BEFORE USE.
ADJUSTING THE SEAT PAD: RAISE THE SEAT PAD TO THE DESIRED POSITION BY USING THE
PULL PIN THOUGH THE HOLES IN THE BRACKET.
FRAME ASSEMBLY
N
G
G
G
A
K
N
K
N
G
G
D
N
M
M
I