Deltech Fitness DF9000- Flat/Incline Dumbbell Bench - Manual (Page 6)

NOTE: IF THE BACKREST OR
SEAT ARE LOOSE OR WOBBLE
TIGHTEN THESE NUTS UNTIL
THEY DO NOT MOVE SIDE TO
SIDE.
(NOTE: THE NUTS USED ON THIS BENCH ARE LOCK NUTS, THIS MEANS YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.) YOU MUST USE A WRENCH TO TIGHTEN!
SEAT & BACKREST INSTALLATION
ATTACH THE THE BACKREST ASSEMBLY AND THE SEAT ASSEMBLY TO THE BODY USING THE M12 x
80MM BOLTS (J), M12 FLAT WASHERS(O), AND M12 LOCK NUTS (Q). * THE TIGHTER YOU MAKE
THESE BOLTS THE MORE STABLE THE BENCH WILL GET. (NOTE: THE LOCK PIN FOR THE SEAT IS
NOT NEEDED IN THE FLAT POSITION.)
NEXT ATTACH THE INCLINE SUPPORT (D) TO THE BACKREST ASSEMBLY USING THE THE M10 x
115MM BOLT (K), M10 FLAT WASHERS (P), AND M10 LOCKNUT (R). USE THE SEAT SUPPORT PIN
SUPPLIED TO ADJUST THE INCLINE.
MAKE SURE ALL BOLTS ARE BEFORE USE. CHECK THE BOLTS PERIODICALLY AND TIGHTEN AS
NEEDED.
J
K
P
P
O
O
Q
R
D