Deltech Fitness DF6000- Abdominal Bench - Manual (Page 5)

ATTACH THE FRONT LEG ASSEMBLY TO THE BODY (E) USING THE M10 x 70MM BOLTS (L),
THE M10 WASHERS (N), AND THE M10 LOCK NUTS (0).
ATTACH THE REAR FOOT (A) TO THE BODY (E) USING THE M10 x 70MM BOLTS (L), THE M10
WASHERS (N), AND THE M10 LOCK NUTS (0). NOW SLIDE THE RUBBER SHOES (I) ON THE
REAR FOOT (A).
INSERT THE LEG TUBE (G) INTO BODY (E). SLIDE THE LEG PADS (D) ONTO THE TUBE AND
SECURE THEM WITH THE MUSHROOM CAPS (K)
ATTACH THE BACKREST (F) TO THE BODY (E) USING THE M10 x 25MM BOLTS (M) AND THE
M10 FLAT WASHERS (N).
PUSH THE SQUARE CAPS (J) INTO THE ENDS OF THE BODY (E).
MAKE SURE ALL THE BOLTS ARE TIGHT BEFORE USE. REMEMBER TO CHECK THEM PERIODICALLY TO MAKE
SURE THEY ALWAYS STAY TIGHT.
MAIN ASSEMBLY
F
D
K
G
J
I
I
A
J
E
M
L
L
N
N
N
N
O
N
O
(NOTE: THE NUTS USED ON THIS
BENCH ARE LOCK NUTS, THIS MEANS
YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.)