Danby DIM2500WDB - Manual (Page 7)

4
OPERATING INSTRUCTIONS
PREPARATION BEFORE USE
1. Remove and properly discard of all packaging.
2. Make sure you have all the accessories and instructions.
3. Place the ice maker in a suitable position (according to previous instructions)
4. Clean the machine before use (according to directions on page 4 & 5)
5. Turn on the self-clean mode before you use your ice maker for the fi rst time. (see Self-Clean Mode operation on page 5)
USING THE ICE MAKER
1. Do not switch on the power source to the ice maker within 30 minutes after moving the ice maker to allows the oil in the
compressor to settle back into the compressor if the unit was tipped.
2. Pour water into the water tank to the “Max Fill Line” (see Fig.A on page 5). You must use potable water (safe to drink
water) to make ice.
3. Press key to start making ice.
Buttons and Icons Functions
Button Start operation, Standby,
Clear faults/ Turn off unit.
SELECT Button Select ice cube size.
ON indicator Power indicator
Bucket full indicator Indicates ice cube fullness.
Add Water indicator Indicates water shortage,
need to add water.
Large indicator
Medium indicator
Small indicator
- Three ice cube sizes.
- Large, Medium, Small.
(Default setting is Med)
CARE AND MAINTENANCE
CLEANING INSIDE
NOTE: Be certain the power is off before cleaning any part of this appliance.
1. Make sure to unplug the appliance before cleaning.
2. Make sure to unplug the appliance before long term storage.
3. Cleaning the water tank:
1). Unscrew the nut and remove rubber plug from the water outlet, drain out all of the water.
2). Use clean warm water and a cloth to clean inside the ice bucket. Flush unit with clean water until the water
fl owing out is clear. Drain all water and reinstall rubber plugs and retighten the nut.
4. Do not use solvents, boiling water, cleaning agents, strong acids or strong Alkali substances for cleaning.
5. If ice maker will not be used for a long time, you should unplug it, drain out all water dry the appliance with a clean cloth
and store the ice maker in a clean place.
6. When you’re fi nished making ice, drain the excess water out of the unit. Do not allow the same water to sit in the unit
overnight or for extended periods of time.
HELPFUL HINTS
• Allow the ice maker cover to remain open for a few minutes after the ice making process is complete.
• Walls, Floor of bucket, Inside Window, and Plastic Parts - Some water deposits and dust can be removed with a
paper towel, others may require a damp cloth.
• Ice Bucket - The ice bucket can be broken if dropped. Remember, do not operate the ice maker without the ice
bucket in place. Do not use abrasive cleaners or sharp utensils on any part of your ice maker.
CONTROL PANEL