Care and maintenance, Troubleshooting – Danby DCF055A1WDB1 User Manual
Page 8
Care and Maintenance
SOME IMPORTANT RULES FOR THE CORRECT USE OF THE
FREEZER
• Never place hot foods in the freezer.
• Never place spoiled foods in the unit.
• Don’t overload the unit.
• Don’t open the lid unless necessary.
• Should the freezer be stored without use for long periods, it is sug-
gested, after a careful cleaning, to leave the lid open to allow the air
to circulate inside the unit in order to avoid the possibility of
condensation, mold or odors.
6
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free
Number for assistance.
Tel: 1-800-26-
(1-800-263-2629).
PROBLEM
POSSIBLE CAUSE
SOLUTION
1) Does not work.
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being used.
• Check connection of power
cord to power source.
• Plug in unit.
• Use proper voltage.
2) Freezer runs
continuously.
• Temperature set too low.
• Lid is not closed.
• Hot food inserted.
• Lid opened too long or too
often.
• Close proximity to heat
source or direct sunlight.
• Set temperature control to
warmer setting
• Close lid securely.
• Be sure food is at room
temperature before inserting.
• Minimize lid openings/
duration.
• Do not place unit close to
heat sources or direct sun
light.
3) Internal temperature
not cold enough.
• No power to unit.
• Power cord is unplugged.
• Temperature set too high.
• Lid is not closed.
• Hot food inserted.
• Lid opened too long or too
often.
• Air flow obstruction.
• Wrong voltage is being used.
• Close proximity to heat
source or direct sunlight.
• Check connection of power
cord to power source.
• Plug in unit.
• Check setting and increase
as needed.
• Close lid securely.
• Be sure that food is at room
temperature.
• Minimize lid openings/
duration.
• Allow room for air to
circulate around unit.
• Use proper voltage.
• Do not place unit close to
heat sources or direct
sunlight.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION