Danby DFF123C2BSSDD - Manual (Page 9)

CHANGING LED LIGHT (please follow the steps below)
We recommend that you start by unplugging your refrigerator unit.
1. Take off the light cover by flicking the bottom tab up (the bottom tab is located at the bottom middle of the light
cover).
2. Take out the LED strip by pulling it down and unhooking it from the port, it is best to use your thumb on the front
of the LED and you fingers at the back near the port.
3. Put in the new LED by inserting it into the port.
4. Once the LED is secured, put the cover back on by inserting the two top tabs in to their slots and pushing the
bottom tab back into place, you should hear a quiet click.
Once you have secured the light cover back on, you can plug your refrigerator back in.
Take off the light cover by
flicking up bottom tab
You will see the LED strip
Unhook the LED strip using
your thumb and fingers Hook the new LED strip to the port
1 2a
3
Bottom tab
Pull the LED strip down
4
Top tabs
Put the cover
back on
Installation Instructions
6
LED strip
2c
2b