Danby DFF092C1WDB - Manual (Page 8)

OPERATING INSTRUCTIONS
MAX MIN
TEMPERATURE
CONTROLS
REFRIGERATOR
CONTROL
FREEZER
CONTROL
Your refrigerator has a separate control for regulating the temperature for each
section independently. The temperature controls (Fig. A) are located at the rear
of refrigerator section.
• The first time you turn the unit on, set the temperature control to “MAX”
in refrigerator section and “MAX” in freezer section.
• The range of the temperature controls are from position “MIN”
to “MAX” (MIN being the warmest and MIN being the coldest). We
recommend starting at the mid-point for both the refrigerator and freezer,
and after a period of 24 to 48 hours (to allow for cooling) adjust if
necessary.
Fig. B
MAX MIN
Fig. A
Please follow the steps below
We recommend that you start by unplugging your refrigerator unit.
1. Take off the light cover by flicking the bottom tab up (the bottom tab is located at the bottom middle of the
light cover).
2. Take out the LED display by pulling it down and unhooking it from the port, it is best to use your thumb on
the front of the LED and you fingers at the back near the port.
3. Put in the new LED by inserting it into the port.
4. Once the LED is secured, put the cover back on by inserting the two top tabs in to their slots and pushing
the bottom tab back into place, you should hear a quiet click.
Once you have secured the light cover back on, you can plug your refrigerator back in.
Take off the light cover by
flicking up bottom tab
You will see the LED display
Unhook the LED display using
your thumb and fingers
Hook the new LED display to the port
1 2
3
Bottom tab
Pull the LED display down
4
Top tabs
Put the cover
back on
CHANGING LED
LIGHT
FEATURES
6