Da-Lite Da-Snap - Manual (Page 3)

3
There are four methods of installation based on the size of the
screen and type of viewing surface. Measure the width of the
viewing area of your screen and refer to the appropriate method
of installation below. The wall bracket diagram shows the type
and quantity of bracket that is supplied based on the size of
the screen.
Method 1: Screens 80" and smaller in viewing width.
Method 2: Screens over 80" up to 96" in viewing width.
Method 3: Screens over 96" in viewing width.
Method 4: Any size screen with High Power® viewing surface.
Installation
Method 1 (Screens 80" And
Smaller In Viewing Width)
Method 1 (Screens 80" And
Smaller In Viewing Width)
4. Attach the small wall bracket to the wall. Refer to Figure 4
for proper orientation. Do not tighten the screws completely.
The bracket should slide up and down easily.
5. Unroll the screen on a clean surface. Do not use newspaper.
The viewing side is rolled to the inside of the roll. Place the
frame over the screen surface, and while lifting the frame with
one hand, snap the screen surface onto the frame with the
other hand while maintaining a steady pull on the surface.
6. Hang the screen on the brackets by hooking the bottom of the
frame onto the small wall bracket and lift up until you can hook
the top of the frame on the top bracket. Push down on the
frame to seat it on the brackets. Refer to Figure 4.
6"
2
Lift
3
1
W
all
Figure 3
Figure 4
1. Use the supplied #10 screws to attach three frame brackets to
the back of the frame as shown in Figure 2.
2. Secure the large wall bracket to wall studs at the desired height.
Make sure the bracket is level. The top of the frame will be 1/8"
above the top of the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the screen.
3. To install the small wall bracket, you must measure the overall
height of the screen frame and subtract 1-3/8". Using that
dimension, measure down from the top edge of the large wall
bracket and mark the wall for two screw holes. The holes should
be centered within the frame and 6" apart. Refer to Figure 3.
Frame Brackets
3-Pieces
#10 Screws
6-Pieces
Large Wall
Bracket
1-Piece
Small Wall Bracket
1-Piece
Figure 2
Overall
Height
Overall Height - 1 3/8"