Set-up instructions care instructions, Accessories – Da-Lite Project-O-Stand User Manual
Page 2
Remove all four legs from the rubber leg holder and screw into threaded inserts.
To adjust leg length, loosen the Sure-Grip Camlock Collars, adjust to desired table
height and tighten collar.
NOTE: The non-skid platform supports up to 125 lbs. with legs completely
extended.
To take down and store your Project-O-Stand, adjust legs to shortest length,
remove from table top and slip into rubber leg holder.
NOTE: Place legs into center slots of leg holder first, then place legs
into outside slots.
Your new Project-O-Stand requires very little care. Dust as needed with a soft
cloth; if required, use mild soap and water to clean off stubborn spots. Abrasive
cleaners should be avoided as they may scratch the legs on both models.
Set-Up Instructions
Care Instructions
Adjust all 4 legs to desired length before assembling to the table.
Model 425 Only
View A
View A
Model 208
Accessory Shelf
Convenient 14½" x 22" x ½" shelf may be used on all Project-O-Stands to create a
convenient storage place for dissolve units, trays, cassettes, and presentation
materials. Shelf is made of wood composition board with plastic laminate top and
vinyl edges.
Model PS-B
Piggy Back Stand
Aluminum rack may be securely attached to Model 203 Project-O-Stand and
allows an additional EKTAGRAPHIC® projector to be stacked above the base unit.
Projector legs drop into vinyl leg cups with adjustable spacing. Unit folds
flat for storage and transportation.
Accessories