Position switch – Da-Lite Slimline Electrol User Manual
Page 2

Important Safety
Instructions
Suggested Methods Of
Installation
Care Of Screens
Accessories
Operating Instructions
When using your video equipment, basic
safety precautions should always be
followed, including the following:
1. Read and understand all instructions
before using.
2. Position the cord so that it will not be
tripped over, pulled, or contact hot
surfaces.
3. If an extension cord is necessary, a
cord with a current rating at least
equal to that of the appliance should
be used. Cords rated for less
amperage than the appliance may
overheat.
4. To reduce the risk of electric shock,
do not disassemble this appliance.
Contact an authorized service dealer
when repair work is required.
Incorrect reassembly can cause
electric shock when the appliance is
used subsequently.
5. The use of an accessory attachment
not recommended by the
manufacturer may cause a risk of fire,
electric shock, or injury to persons.
Save These Instructions
To Lower Screen Surface
Press lower end of slide switch.
Screen will stop in the “DOWN”
position automatically.
To Raise Screen Surface
Press upper end of slide switch.
Screen will stop in the “UP” position
automatically.
To Stop Screen
Screen may be stopped in any
intermediate position by positioning
slide switch to center “OFF” position.
NOTE: It is suggested that when
screen is not in use, the slide switch
should be positioned to center “OFF”
position.
1. Examine surface to be sure it is free of insects, dirt or foreign matter before
rolling into case.
2. Screen may be operated as frequently as necessary but should not be run up
and down continuously. To do so will cause the motor to overheat and the
thermal overload to cut out. Should this occur, it will be necessary to wait for
the motor to cool sufficiently to resume operation.
3. Motor does not require lubrication.
Picture
Surface
Picture
Surface
Picture
Surface
Picture
Surface
Wall Bracket
Use No. 6
brackets to
hang from
beam or
valance
Ceiling
Mounting
Place “D” rings
over hooks well
secured in ceiling.
Wall Mounting
Slip hanger
eyes over
screws well
secured in wall.
Concealed
Allow room for access
No. 6 Wall Bracket
Non-adjustable permits screen
to extend 6" from wall.
No. 11 Wall Bracket
Non-adjustable permits screen
to extend 10" or 14" from wall.
3-Position Switch
3-Position Switch
Complete with cable,
is standard with the
Slimline Electrol.