Da-Lite Designer Contour Electrol with Integrated Infrared Remote - Manual (Page 3)

3
Installation
Carefully unpack screen and remove outer wrapping from case.
Remove the black tape from the slat bar after the case has been
installed.
There are three ways to install the Designer Contour® Electrol® with
built-in Infrared Remote: Wall Mount, Ceiling Mount, or Ceiling Hook.
Procedures for each method are as follows:
Wall Mount
1. Secure the wall mount bracket to the wall at the desired height.
Bracket should be fastened to wall studs or some reinforcement
within the wall. Concrete or brick walls require special fasteners
and anchors.
2. Make sure the bracket is level. See figure 1 for reference
dimensions.
3. Keep in mind you will need at least 5/8" between the ceiling and
the top of the wall mount bracket to be able to position the case
on the bracket.
4. Mount the screen case on the wall bracket as shown in figure 1.
Be sure the case is fully seated on the bracket. Tighten the stop
screws against the wall bracket.
Ceiling Mount
1. Do not remove the wall mount bracket, even if you are not using
it for mounting. This provides structural stability to the case.
2. Be sure the ceiling has adequate reinforcement to attach the
screen brackets.
3. The top of the screen case has a channel that the ceiling mount
brackets slide into. Remove the end cap on the right end of the
case and insert the brackets into the case channel. Lock the
brackets in place by tightening two set screws. Refer to figure 2.
Mount can not be more than 12" from end of case.
4. Hold the screen case up to the ceiling and mark the hole
locations. Drill holes into the ceiling and attach screen with the
appropriate fasteners for your ceiling.
Ceiling Hook
1. Do not remove the wall mount bracket, even if you are not using
it for mounting. This provides structural stability to the case.
2. Be sure the ceiling has adequate reinforcement to attach a hook
anchor.
3. The top of the screen case has a channel that the ceiling hook
brackets slide into. Remove the end cap on the right end of the
case and insert the brackets into the case channel. Lock the
brackets in place by tightening two set screws. Refer to figure 3.
4. The brackets can be attached anywhere within 12" of the end of
the case.
5. Attach an S-hook or similar fastener to the large center hole on
the bracket.
Figure 1
5/16"
9/16"
Case Hook
Wall Mount
Bracket
4 1/4"
4 5/8"
Stop Screw
Figure 2
Set Screws (2)
Ceiling
Mount Holes
Endcap
Endcap
Screws (3)
Figure 3
Set Screws (2)
Hook Mount
Hole
Endcap
Endcap
Screws (3)