Da-Lite Cambridge Lectern - Manual (Page 2)

2
To remove lectern top from projector stand base, disconnect
power cord and turn the black knob (located under the middle
shelf) counter-clockwise until disengaged. Lift off lectern top and
place in desired location.
Projector stand base features a 110/120 VAC Duplex receptacle
for equipment. Plug line cord into approved 3-wire 110/120 V
outlet. To assemble, reverse this procedure.
Stacking Models
All Models Optional Height Adjustment
Power
Connect power supply to 110/120 VAC 3-wire outlet
(220/240 VAC models to 220/240 VAC source).
Reading Light
Depress light switch to activate light. ADJUST VISOR AS
NECESSARY. Use GE 25T8DC 110v appliance lamp or equivalent
when relamping all 110/120 sound and non-sound lecterns;
GE 1176 12v for 220v lecterns.
Digital Clock/Count Down Timer
Select desired mode; adjust time with SET switch. Unit will
remain operational as long as the main power supply is on.
NOTE: Power interruptions will cause the clock to flash until reset.
Models with optional reading surface adjustment are controlled
by the switch marked HEIGHT and provide up to 8 - 9 inches of
elevation. To raise or lower, depress HEIGHT switch.