Clearaudio Innovation Compact + Stroboscope Testrecord - Manual (Page 9)

Innovation Compact
User manual
Page 8  Clearaudio electronic GmbH 2015
5.)
In the next step remove the lamination of the sensor, mounted on the turntable chassis
(picture 6: red frame).
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
6.)
6.1.
Take the platter with both hands (with white gloves) carefully out of the packing.
Please pay attention that the integrated bearing does not fall out of the platter!
The flat side of the platter should face to the chassis and the side with the cut-out (for the
record) should face up.
6.2.
In the next step remove the lamination of the sensor on the bottom side of the platter.
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
6.3.
With both hands you can place the platter carefully onto the bearing.
Through a lightly (!!) up and down movement the platter will slip onto the bearing upper
part (picture 7).
Avoid major side forces to prevent any damages
to the ceramic bearing!
To avoid any damages on your bearing, the platter
should have room temperature before the set up begin
(approx. 20 ° Celsius).
Make sure with gentle pressure that the platter is applying on the complete surface of the
bearing.
Pic. 6: Removing the lamination
Pic. 7: To set up the platter