ClassCo InTouch 510 - Manual (Page 10)

Operation
Your modem session must be active for at least 60-seconds
(allowing time for the modem connection to become stable)
before the InTouch 510 can detect calls. The LED on the front of
the unit indicates the status of your modem and the InTouch 510
unit:
LED State Status
Steady Green Modem not in use
Blinking Green Modem connecting
Steady Red Ready to detect incoming calls
Blinking Red Incoming call detected
Receiving Calls when you are on the Internet
When an incoming call has been detected, the LED will flash Red
and the unit will beep for up to 10-seconds or until the call is
answered. At this point, you have three options:
1. Answer the telephone plugged into the unit. The unit will
isolate the modem from the line and automatically connect you to
the calling party. When you hang-up, the connection between
the modem and the line may be restored. However if your
conversation is much longer than ten seconds, the data
connection may have been terminated. (This depends on how
long your ISP waits before automatically disconnecting.)
2. Do nothing and ignore the call. If you have network voicemail
service, your call will be routed to voicemail automatically by
your telephone company
3. Hang up on your Internet session from your computer. If you
do this within 10-15 seconds, your telephones will start to ring
and you can answer the call from any telephone extension.
10