Cino L780BT HC - Manual (Page 11)

Batch Scanning (Inventory Mode)
Thanks to the specially designed Batch Scanning function, the scanner is
capable of storing the barcode data up to 20,000 EAN-13 labels. It is an ideal
cost-saving solution for inventory applications.
Once you scan the “Enter Batch Scanning” command to activate this function,
all scanned barcode data will be stored into the memory storage, and the
status indicator of scanner will give green blink at regular interval during
batch scanning. You can scan and store the barcode data till the memory
storage is full. If the storage is full, you will hear 2 long beeps and the status
indicator will give 2 red blinks to indicate out of storage. To terminate the
batch scanning, please scan the “Exit Batch Scanning” command.
Enter Batch Scanning
Exit Batch Scanning
How to Transmit Stored Data
The scanner is preset to scan the “Transmit Stored Data” command to
transmit all stored data. During the transmission process, the scanner will
give continuous short clicks and blue blinks. Then the scanner will give two
short beeps after data transmission is completed.
Transmit Stored Data
But you are still able to set the scanner to transmit the stored data by placing
the scanner onto the cradle as well.
Transmit Stored Data by
Scanning Barcode Command ◆
Transmit Stored Data by
Placing Scanner onto Cradle
Transmit Stored Data by
Scanning Barcode or Placing Scanner onto Cradle
The scanner is preset to keep all the stored data until you scan the “Clear All
Stored Data” command. But you are still able to change the setting to “Auto
Delete Stored Data after Transmission” as well.
Clear All Stored Data
Keep Stored Data
after Transmission ◆
Auto Delete Stored Data
after Transmission
10