Avalue EMX-QM67 - Manual (Page 8)

EMX-QM67
EMX-QM67 Quick Installation Guide 8
2.2 Jumper and Connector List
You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board's jumpers and connectors.
Specifications
System
CPU
Intel rPGA988 Socket (Socket G2) supports Intel Core i7/ i5/ i3/ Celeron Mobile
CPU
BIOS AMI 16Mb SPI
System Chipset
Intel® QM67
I/O Chipset
Nuvoton NCT6776F
Memory
Two 204-pin SODIMM support up to 16GB dual channel DDR3 1333/ 1066, up
to 16GB
Watchdog Timer Reset: 1 to 255 sec/min per step
H/W Status Monitor
Monitoring temperature, voltage and cooling fan status. Auto throttling control
when CPU overheats.
Expansion Slots 1 PCI-E x 16 Gen. 2, 1 Mini PCI-E x 1, 1 CFast Card Connector
Power State S1, S3, S4, S5
Wake up on LAN or Ring LAN (WOL) and Ring (WO)
Smart Fan Control Yes
Smart Fan Control Supports 3 modes (Silent/Optimal/Performance)