Austroflamm Irony Fireplace 1 - Manual (Page 8)

english 6 Irony Fireplace 1
Heating in-between seasons
Heating the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood and the primary air has to
be increased so that the wood can burn down faster
(with visible flames) and thus the chimney flue can
stabilize.
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. Close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an
expert inspect your chimney for cracks and air-
tightness after the burning out of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr. drawing Part number
Round gasket 16 mm (3m) 20 715600
Round gasket 14 mm (2 m) 21 718429
Flat gasket 8 x 2 mm (3 m) 23 710096
Keramott
Description Nr. drawing Part number
FP1 wood retainer, Keramott 1 794514-FP
FP1 bottom left, Keramott 2 794414-FP
FP1 bottom right, Keramott 3 794418-FP
FP1 rear, Keramott 4 794224-FP
FP1 side component left, Keramott 5 794120-FP
FP1 side component right, Keramott 6 794129-FP
FP1 baffle plate, Keramott 7 794614-FP
Keramott supporting angle left 8 784008-29
Keramott supporting angle right 9 784007-29
FP1 bottom middle, Keramott 13 794224-FP
Other parts
Description Nr. drawing Part number
FP1 door glass 22 795324
Stove lacquer -- 640138
Wood lighter can à 100 pcs. -- 640162
Glass cleaner ½ litre -- 640070
Accessories
You can obtain floor plates of glass or steel, fireplace utensils, care products or the Heat Memory System
for heat storage from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely.
The fireplae must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection
intervals. An expert should inspect the stove annually.
Keramott numbering = installation instructions!
7
5
2
1
9
8
4
6
3
10