The most important spares—overview, Heating in-between seasons, Chimney fire – Austroflamm Stila User Manual
Page 9: Gaskets, Keramott, Other parts, Accessories, Important, Maintenance, Cleaning

english
7 Stila
Heating in-between seasons
If you heat the stove in between seasons, when the 
outside temperatures are higher, the flue gases may 
not be able to escape completely and this may lead to 
disturbances in the chimney draught, especially if the 
temperatures are rising suddenly. The stove has to 
be charged with less wood then and the primary air 
has to be increased so that the wood can burn down 
faster (with visible flames) and thus the chimney 
draught can stabilize. 
 
Chimney fire
A chimney fire may occur, due to sooting and 
deposits in the chimney, if wrong or humid fuel is 
used. In case of a chimney fire close all air inlets on 
the fireplace/chimney immediately and call the fire 
brigade. Please have an expert inspect your chimney 
for cracks and air-tightness after the burning out of 
the chimney. 
3. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr.drawing Part
number
Gasket flat 10x5 mm, L=2300 mm
9
718438
Gasket 15x8 mm, L=2200 mm
10
718571
 
Keramott 
Description Nr.drawing Part
number
Baffle plate Keramott
1
715880
Wood retainer, Keramott
2
719591
Bottom right, Keramott
3
719593
Bottom left, Keramott
4
719592
Bottom rear, Keramott
5
719594
Side Keramott
6
719595
Rear Keramott
7
719596
Baffle plate Keramott
8
719597
Other parts
Description Nr.drawing Part
number
Door complete
11
719580
Door handle
12
719570
Door glass
13
719540
Glass cleaner ½ litre
--
640070
Stove lacquer
--
650002
 
 
Accessories
You can obtain floor plates of glass or steel or care products from your certified dealer. 
 
IMPORTANT:
Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely. 
The fireplace must not be amended. 
 
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered 
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used 
for stainless steel surfaces. 
 
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if 
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned 
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection 
intervals. An expert should inspect the stove annually. 
 
 
Keramott numbering = installation instructions
