Austroflamm Pallas - Manual (Page 8)

Pallas 6 english
Heating in-between seasons
If you heat the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood then and the primary air
has to be increased so that the wood can burn down
faster (with visible flames) and thus the chimney
draught can stabilize.
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. In case of a chimney fire close all air inlets on
the fireplace/chimney immediately and call the fire
brigade. Please have an expert inspect your chimney
for cracks and air-tightness after the burning out of
the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr. drawing Part number
Flat gasket 8 x 2 mm 13 710096
Round gasket 6 mm (0,5 m) 14 710696
Round gasket 14 mm (2,1 m) 15 710338
Keramott
Description Nr. drawing Part number
Bottom Keramott left 1 712766
Bottom Keramott right 2 712767
Bottom Keramott centre 3 712760
Rear, Keramott 4 712761
lateral Keramott right 6 712763
lateral Kermott left 5 712762
Keramoot baffle plate 7 712764
Keramott wood retainer 8 712765
Other parts
Description Nr. drawing Part number
Pallas door glass 10 712759
Door Handle 11 712786
BA1 spring 12 715641
Stove lacquer -- 650002
Glass cleaner ½ litre -- 640070
Accessories
You can obtain floor plates of glass or steel, care products or the Heat Memory System for heat storage from
your certified dealer
.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your stove
functions properly and safely.
The fireplae must not be amended
.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered surfaces are
to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used for stainless steel
surfaces
.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by
the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection intervals. An expert
should inspect the stove annually.
order of Keramott installation acc. to numbering
3
4
7
8
1
2
5
6