Austroflamm Koko 2.0 - Manual (Page 9)

Koko 2.0 7 english
Heating in-between seasons
Heating the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood and the primary air has to
be increased so that the wood can burn down faster
(with visible flames) and thus the chimney flue can
stabilize.
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. Close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an
expert inspect your chimney for cracks and air-
tightness after the burning out of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr.drawing Part number
Flat gasket 8x2, L=1425 mm 5 710096
Door flat gasket 8x2, L=1420 mm 6 710096
Gasket round DM 14x2100 grey 8 714223
Keramott
Description Nr.drawing Part number
Bottom left, Keramott 1 714383
Bottom right, Keramott 2 714382
Rear, Keramott (2 pcs.) 3 714384
Side component left, Keramott 4 714386
Side component right, Keramott 5 714385
Baffle plate rear, Keramott 6 714381
Wood retainer, Keramott 7 714380
Grate 8 716408
Other parts
Description Nr.drawing Part number
Koko 2.0 door 1 719977-29
Door handle 2 714410
Koko 2.0 door spring 3 719996
Koko door glass 4 714442
Glass cleaner ½ litre -- 640070
Stove lacquer -- 650002
Accessories
You can obtain floor plates of glass or steel, care products or the Heat Memory System for heat storage
from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely.
The fireplae must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection
intervals. An expert should inspect the stove annually.
Keramott numbering = installation instructions!