Angelcare AC300 User Manual

Page 6

STEP 2 - SETTING UP THE NURSERY UNIT

1) Remove the battery door and insert

2 AA Alkaline Batteries (not included).

2) Place the Nursery Unit at a minimum

of 1 m away from the crib.

NURSERY UNIT:

Front Side

Back Side

A) Movement ‘TIC’

ON/OFF button

B) POWER ON/OFF switch

C) Movement ‘TIC’

Indicator (flashing)

D) Alarm Indicator

E) Low battery indicator

F) Movement sensitivity

adjustment dial

G) Sensor Pad socket

H) Battery Door (not shown)

3.1 - SENSOR PAD

1) Turn ON Power/‘TIC’ switch

2) Move your hand lightly on the mattress.

3) Remove your hand from the mattress.

After 15 seconds you will hear a ‘TIC’
pre-alarm sound.

4) 5 seconds later the alarm will sound and

the red light (Alarm Indicator) will flash
continuously.

Test monitor when moving Sensor Pad to a new location to ensure sensitivity
is adjusted correctly to the new padding or mattress.

IF THE ALARM DOES NOT SOUND

TO TEST SENSOR PAD:

MOVEMENT ALARM

• If NO movement is detected after

15 seconds you will hear a single ‘TIC’
pre-alarm sound from the Nursery Unit.

• If after a further 5 seconds there is still

NO movement detected, Nursery Unit
speakers will emit a loud warning sound.

• Avoid contact with crib

while Sensor Pad is in operation.

• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.

STEP 3 - TESTING AND GETTING TO kNOW YOUR MONITOR

TO STOP THE ALARM

Place your hand
back on the
mattress.

Shut the Nursery
Unit OFF

Keep

at least

1 m