Acrosser AR-B1551 - Manual (Page 36)

AR-B1551 User’s Guide
35
5.7 INTEGRATED PERIPHERALS
This section is designed to configure the peripheral features.
ROM PCI/ISA BIOS (2A434AVF)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
Multiple Monitor Support
Video Memory Size
:
: No Onboard
: 2.5M
Esc: Quit
F1: Help
F5: Old Values ↑↓→←: Select Item
PU/PD/+/-: Modify
(Shift) F2: Color
IDE HDD Block Mode
Primary IDE Channel
Master Drive PIO Mode
Slave Drive PIO Mode
IDE Primary Master UDMA
IDE Primary Slave UDMA
KBC input clock
Onboard Serial Port 1
Onboard Serial Port 2
Onboard IR Controller
Onboard Parallel Port
Parallel Port Mode
: Enabled
: Enabled
: Auto
: Auto
: Disabled
: Disabled
: 8 MHz
: 3F8/IRQ4
: 2F8/IRQ3
: Disabled
378/IRQ7
SPP
F6: Load BIOS Defaults
F7: Load Setup Defaults
Integrated Peripherals
IDE HDD Block Mode
This option allows your hard disk controller to use the fast block mode to transfer data to and from your hard disk
drive (HDD).
Enabled IDE controller uses block mode.
Disabled IDE controller uses standard mode.
IDE PIO
IDE hard drive controllers can support up to two separate hard drives. These drives have a master/slave
relationship, which is determined by the cabling configuration used to attach them to the controller. Your system
supports one IDE controller – a primary and a secondary – so you have the ability to install up to four separate
hard disks.
PIO means Programmed Input/Output. Rather than have the BIOS issue a series of commands to affect a transfer
to or from the disk drive, PIO allows the BIOS to tell the controller what it wants and then let the controller and the
CPU perform the complete task by themselves. This is simpler and more efficient (and faster). Your system
supports five modes, numbered from 0 to 4, which primarily differ in timing. When Auto is selected, the BIOS will
select the best available mode.
KBC input clock
This item it to chose the input clock of Keyboard Controller
OnBoard Serial Port 1 & 2
These options are used to select the port address of the on-board serial port A. The options are 3F8H, 2F8H,
3E8H, 2E8H, Auto and Disable. Port 1 is COM A, Port 2 is Com D and so on. Port four can be set to be IrDA
(Choose Auto) if the IrDA device has been connected.
OnBoard Parallel Port
This option is used to select the port address of the on-board parallel port. The options are 378H, 278H, 3BCH,
and Disabled.
Parallel Port Mode
This option specifies the parallel port Mode. The settings are Printer or Extended (Bi-direction).