Acrosser AR-B1690 - Manual (Page 23)

AR-B1690 User’s Guide
23
3. CRT/LCD FLAT PANEL DISPLAY
This chapter describes the configuration and installation procedures for LCD & CRT displays. The following topics
are covered:
! CRT Connector
! LCD Flat Panel Displays
※ DON´T SUPPORT EXTERNAL VGA CARD
3.1 CRT CONNECTOR (VGA1)
The AR-B1690 supports CRT color monitors. It uses an onboard VGA chipset and you can use the VGA RAM
2.4 or 8 MB. For different VGA display modes, your monitor must possess certain characteristics (the right drivers)
to display the mode you want.
To connect to a CRT monitor, an adapter cable has to be connected to the VGA connector. VGA is used to
connect with a VGA monitor when you are using the on-board VGA controller as a display adapter. Pin assignments
for the VGA connector are as follows:
6
10
11 1
2
3
4
5
2 Green
12
15
14
13
3 Blue
13 Horizontal Sync
14 vertical Sync
9 VCC
5&10 Ground
1 Red
6,7&8 AGND
VGA1
12 SDA
15 SCL
4,11 N.C
VGA1: CRT Connector
3.2 LCD FLAT PANEL DISPLAYS
Figure 4-2 shows the connection between AR-B1690 and LCD panel.
LCD Panel Block Diagram
The VGA BIOS of AR-B1690 support 800X600 resolution TFT display. Connecting AR-B1690 to other LCD needs
different LCD BIOS. Please visit our web site (
www.acrosser.com ) or contact with our technical support
department ( [email protected] ) for supports of LCD connecting.
CN 11
AR-B1690
LCD
Panel
Inverter
12V & backlight
Control Backlight
Power
AR-B9416