Installation, 1 overview, 2 utility diskette – Acrosser AR-B1550 User Manual

Page 23: 1 driver installation

AR-B1550 User

s Guide

4. INSTALLATION

This chapter describes the installation procedure. The following topics are covered:

l Overview
l Utility Diskettes

4.1 OVERVIEW

This chapter provides information for you to set up a working system based on the AR- B1550 CPU board. Please
carefully r ead the details of the CPU board’s hardware descriptions before installation. Pay special attention to the
jumper settings, switch settings and cable connections.

Follow steps listed below for proper installation:

Step 1:

Read the CPU board’s hardware description in this manual.

Step 2 :

Set jumpers.

Step 3 :

Make sure that the power supply connected to your AR-B1550 CPU board is turned off.

Step 4 :

Connect all necessary cables. Make sure that the HDC; serial and parallel cables are connected to
pin 1 of the related connector (not upside down).

Step 5:

Connect the hard disk flat cables from the CPU board to the drives. Connect a power source to
drive.

Step 6:

Plug the keyboard into the keyboard connector.

Step 7:

Turn on the power.

Step 8:

Configure your system with the BIOS Setup program (section 5) then re-boot your system.

Step 9:

If the CPU board does not work, turn off the power and read the hardware description carefully
again.

Step 10:

If the CPU board still does not perform properly, return the board to your dealer for immediate
service.

4.2 UTILITY DISKETTE

The AR-B1550 provides three utility diskettes.

4.2.1 Driver Installation

The AR-B1550 provides LAN function drivers for the WIN95, WIN98, WIN2000, WINCE, LINUX, and NT. The
driver can auto-setup in the specified mode. The user must first decompress the compressed file.

The 1

step: Decompress the zip files included in the diskettes to your hard disk.

The 2

step: Execute the corresponding f iles to setup the system.

The files list and descriptions are as follow: