Acrosser AR-ES0631ET - Manual (Page 6)

AR-ES0631ET Installation Guide
2. Procedure of Assembly/Disassembly
2-1 Installing the 2.5”Hard Disk Drive (HDD)
The following are step-by-step installation
1. Insert the anti-vibration rubbers into the four edge of HDD bracket bay
2. Connect the IDE cable to the 44-pin header of HDD
3. Put the HDD on the HDD bracket and screw them together via four
screws
4. Remove the CPU board out from the AR-ES0631ET for installing the HDD
module later
Fig.1 HDD bracket bay
5. Remove the back cover of AR-ES0631ET by unlocking the two screws
Fig.2 Back cover
Unlock the
screws
6