3DLABS Oxygen VX1-16 - Manual (Page 13)

Installation
3Dlabs Oxygen VX1-16 User's Guide 3
Installing Hardware
The Oxygen VX1-16 is an AGP form-factor card. Check the documentation for your system for the location
of the AGP expansion slot in your system.
To remove an old card from your system
1. Make sure you have uninstalled any old drivers and installed the Oxygen driver in their place.
2. Turn off and unplug the power source for your system and each of
its peripherals.
3. Unplug the monitor cable from the old card.
4. Remove the cover from your system.
5. Remove any screws securing the card to the chassis.
6. Lift the card out of the slot.
To install your Oxygen card
1. Turn off and unplug the power source for your system and each of its peripherals, if you have not
already done so.
2. Remove the cover from your system so you can access the appropriate expansion slot. See your system
documentation for the AGP slot location(s).