Connecting a stereo display device – 3DLABS Wildcat 4110 User Manual

Page 21

Figure 4. Device Manager showing Chips and Technologies 655554 Graphics Adapter

Connecting a Stereo Display Device

The following instructions apply only if you are connecting a stereo video display device to the Wildcat
4110 PRO video card.

To connect a stereo display device:

1. Connect one end of the stereo emitter cable to the input port on your stereoscopic display

device.

NOTE:

See the documentation delivered with your stereoscopic display device for information on the
connectors and proper cables.

2. Connect the other end of the cable to the stereo output port on the Wildcat 4110 PRO

video card (see Figure 5).

3. Configure the display settings to enable stereo display. See Chapter 3, “Using the Video

Card,” for step-by-step instructions.