Directed Electronics Hurricane Vehicle Security System G Hurricane 3 6 - Manual (Page 24)

21
© 2000 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To arm your system using your remote
■ Press for one second to arm the system and lock the doors. When
the system arms, you will hear one chirp and the parking lights will flash
once.
To disarm your system using your remote
■ Press to disarm the system and unlock the doors. When the system
disarms, you will hear two chirps and the parking lights will flash twice.
Arming your system while driving
■ Press and hold for 1.5 seconds while the vehicle is running. You will
hear one chirp that confirms that the vehicle is armed and a second
chirp that indicates that the ignition is on.
Disarming your system without a transmitter
■ To disarm without a transmitter, you must have the vehicle's ignition key
and know where the Valet switch is located. (Contact your installer for
both the location and the preset number of presses required for the Valet
switch). Turn on the ignition key. Press the Valet switch the pre-pro-
grammed number of times within 15 seconds. If the system does not
disarm, you may have waited too long; turn the ignition off and repeat
the process.
To enter or exit Valet Mode
■ To enter or exit Valet Mode, turn the ignition key on and then off. Then
press and release the Valet switch within 10 seconds. The status LED will
light steadily if you are entering Valet Mode and will turn off if you are
exiting Valet Mode.
To activate Panic Mode
■ Press and hold for 1.5 seconds.
To exit Panic Mode
■ Press , , or .
To activate Silent Mode
■ Press briefly before arming or disarming. The confirmation
chirp(s) will be eliminated for that one operation only. Cut along dotted line and f
old f
o
r a quick and eas
y r
efer
ence to k
eep in y
our pur
se or w
allet.
✂✂
✂ ✂