beautypg.com

Owner’s manual, Product identification, Local codes – Desa B User Manual

Page 3: Unpacking product features

background image

3

104414

OWNER’S MANUAL

PRODUCT
IDENTIFICATION

Figure 1 - Split Oak Design Model

Front
Branch

Control Knob

Rear Log

Base Assembly

Front
Burner

Piezo
Ignitor

Rear
Burner

Crossover Log

Middle Log

LOCAL CODES

Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1
, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note:

Where listed vented decorative logs

are required, thermostat models are not
permitted.

OPERATION

This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
both realistic flames and glowing coals.
This heater is designed for vent-free opera-
tion with flue damper closed. It has been
tested and approved to ANS Z21.11.2 stan-
dard for unvented heaters. State and local
codes in some areas prohibit the use of vent-
free heaters. This heater may also be oper-
ated as a vented decorative (ANS Z21.60)
product by opening the flue damper (non-
thermostat models only).

SAFETY DEVICE

This heater has a pilot with an Oxygen
Detection Safety Pilot System (ODS). The
ODS/pilot is a required feature for vent-free
room heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.

1.

Remove logs and heater base assem-
bly from carton.

Note:

Do not pick up

heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.

2.

Remove all protective packaging ap-
plied to logs and heater for shipment.

3.

Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.

UNPACKING

PRODUCT
FEATURES

CAUTION: Do not remove

the metal data plates from the
grate assembly. The data plates
contain important product in-
formation.

This manual is related to the following products: