DigiPower ENG Lenses - Manual (Page 4)

4
4. Manual Operation
a. Set the servo/manual select switch to “M”.
b. Rotate the zoom ring directly or using the zoom lever. Clockwise
rotation of the zoom ring, viewed from the camera side, moves the
zoom to the wide side, and counterclockwise rotation to the tele side.
(When rotating the zoom ring directly, it is recommended to remove
the zoom lever for smooth operation. If you removed the zoom lever,
install it on the zoom lever holder so as not to lose it.)
5. Zoom Limit Operation
The zoom limit function can be used in the servo operation mode. (The setting of
the zoom limit positions can be set also in the manual operation mode.) By using
this function, the zoom movement toward both tele and wide side can be
confined; therefore, zooming can be done within the desired shot angles.
Note: While the zoom limit function is being used, the preset function cannot be
used.