Danby DWC516BLS - Manual (Page 10)

Installation Instructions - Door Swing Reversal
FIG 1A
9
1. Unplug the unit from electrical oulet (if connect-
ed) and lay it on it’s back.
2. Open the door until the screws securing the
lower door support bracket are exposed on the
bottom of the door (
Fig 1B).
3. Remove the screw that is closest to the hinge assem-
bly and gently close the door to remove the remaining
screw from the support bracket.
4. Swing the door slightly towards the left side in
order to remove the support bracket from the door
and the lower hinge assembly.
5. Pull the door downward to remove it from the
cabinet of the wine cooler.
6. Remove the cap from the top left side of the
door (
Fig 1D) and reinstall it on the top right side.
7. Remove the three (3) screws supporting the
top hinge (
Fig 1A) and the three (3) screws sup-
porting the bottom
hinge.
8. Remove the plastic caps from the left side of
the frame (
Fig 1C) and reinstall them on the right
side of the frame (the previous hinge location).
9. Install the new left hand hinge assembly (sup-
plied with unit) on the left side of the frame.
10. Insert the lower door support into the left side
bottom hinge.
11. Carefully reposition the door firstly into the left
side upper hinge assembly then onto the lower
door support bracket.
12. While the door remains closed install the first
screw into the lower support bracket.
13. Open the door and install the screw that is
closest to the hinge assembly.
14. Close the door and return the unit into it’s
upright position (
wait 60 mins before reconnect-
ing power to the wine cooler), verify the door
alignment and proper seal against the cabinet.
FIG 1C
Plastic Caps (3)
Upper Hinge
FIG 1D
Door Plug
Lower Hinge Assembly
and Door Support Bracket
FIG 1B