Audiovox FR-100 - Manual (Page 4)

BATTERY INSTALLATION
Your radio requires four “AAA” alkaJme ceUs or four rechargeable
“AAA” nickel cadmium cells. Alkaline batteries will provide your
transceiver’s best range and preformance. Remove the battery cover
by releasing the clasp at the bottom of the unit and lifting the cover
from the battery compartment. Observe the polarity symbols inside
the battery tray when installing the batteries.
CAUTION: Incorrect battery installation can damage the unit.
I
HOW TO OPERATE YOUR RADIO
TO RECEIVE
1. Turn the power on.
2. If the “Battery Low” indicator, is on charge or replace the batteries.
3. Adjust the volume control to the desirable listening level by
pres-sing and holding the monitor button while turning the volume
control knob.
TOTRANShOT
1. Turn the power on.
2. If the “Battery Low” indicator is on, charge or replace the batteries.
3. To transmit, press the Push-to Talk button. Speak slowly and
clearly in a normal voice, approximately 2-3 inches from the
microphone. A built-in modulation control circuit will
automatically adjust the microphone input level. There’s no need to
speak loudly.
4. To receive, release the Push-to-Talk button
TO SET THE DESIRED CHANNEL
1. Remove the battery cover.
2. Remove the battery on the far right.
3. Below this battery' is a bank of four Dip Switches.
4. Adjust the switches as per the chart on page 8.
NOTE: The up position is toward the top of the radio