Delta D1600e - Manual (Page 8)

8- ENG D27665
3. Connect wand to gun. Tighten
securely. See figure 5.
BEFORE STARTING
1. Move pressure washer to level
ground.
2. Make sure the ON/OFF switch is in
the OFF position
Figure 5
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
When using the high pressure setting, DO NOT allow the
high pressure spray to come in contact with unprotected skin,
eyes, or with any pets or animals. Serious injury can occur.
Your washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
Never pull water supply hose to move pressure washer. This
could damage hose and/or pump inlet.
Always keep unit in a vertical position
.
DO NOT use hot water, use cold water only.
Never turn water supply off while pressure washer motor is running or damage
to pump will result.
This unit is equipped with an automatic stop mode. When the trigger is released
the motor is shut off automatically. When the trigger is pressed again the motor
will automatically start. The time between release and engagement must not be
less than 4-5 seconds. DO NOT leave the unit in automatic stop mode for more
than 15 minutes.
Stand on a stable surface and grip gun/wand firmly with both hands. Expect
the gun to kick when triggered.
This product is intended for intermittent use only. Operate pressure washer
one hour or less in a 2 hour period.
If you do not understand these precautions please call 1-866-422-4286 to
speak to a service representative for further instructions.