Danby DAC14004D - Manual (Page 18)

E-
18
Solving Common Problems
Explanation / Solution
◆ Check that the circuit breaker used for the air conditioner has not been
triggered.
◆ Check that the power cable is plugged into a wall socket and the socket is
switched on, if necessary.
◆ Check that the temperature indicator on the unit is lit; if necessary,
press the (On/Off) button on the remote control or unit.
◆ Check that there are no obstacles between you and the unit.
◆ Replace the remote control batteries if necessary.
◆ Check that you are close enough to the unit (seven metres/yards or less).
◆ Ventilate the room.
Problem
The air conditioner does
not
operate at all
The air conditioner does not
operate with the remote
control
Odors are permeating the
room during air conditioning
◆ Check that you are pointing the remote control at the remote control sensor
on the unit.
◆ Replace the remote control batteries if necessary.
No beep is heard when you
press the
(On/Off) button
on the remote control
◆ Check that the correct operating mode has been selected(Cool).
◆ The room temperature may be too low.
◆ Dust may be blocking the air filter; refer to page 17 for cleaning instructions.
◆ Check that there is no obstacle blocking the air flow into or out of the unit.
The air conditioner does not
cool
◆ Check that the timer has been programmed correctly; refer to page 12~14. The timer is not correctly trig-
gered
Before contacting an authorized service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.