Siemens MS 65598 - Manual (Page 5)

en
Safety Information
/K
Risk of injury
Connect and operate the appliance only in
accordance with the specifications on the rating
plate.
Do not use if the cord or appliance is damaged.
Keep children away from the appliance.
Supervise children to prevent them from playing
with the appliance.
Do not allow persons (also children) with
restricted physical sensory perception or mental
abilities or with lack of experience and know­
ledge to operate the appliance unless they are
supervised or have been instructed in the use of
the appliance by somebody who is responsible
for their safety.
After using the appliance, if leaving the appliance
unattended or if the appliance malfunctions,
ALWAYS pull out the plug. Do not place the
power cord over sharp edges or hot surfaces.
To prevent injury, a damaged power cord must
be replaced by the manufacturer or his
customer service or a similarly qualified person.
Only our customer service may repair the
appliance.
Make out-of-service appliances unusable.
Blade is very sharp. After switching off, the drive
continues for a short time. After work, set cutting
width to 0 .
Do not operate the appliance without the
carriage and “sausage end” holder.
Do not immerse power tool in water or clean
under running water.
Operating the appliance
Before using the appliance for the first time,
clean thoroughly.
Preparation
Fig. A
• Place the appliance on a smooth,
clean surface.
• Stow the cord in the cord store (9).
- Remove cable from the two clamping
slots ( 1. ).
- Pull out/push in cable past the cover
to the required length ( O. ).
- Re-attach cable end ( 3. ).
• Insert the plug.
• Attach the carriage (5) and “sausage end”
holder (8).
• Set required cutting width (1).
Switching the appliance ON/OFF
/f\
Risk of injury from the sharp biade
When the appliance has been switched OFF,
the blade continues rotating briefly.
Never place hands near the blade.
Warning! Motor may overheat.
After a maximum 10 minutes of continuous
use, switch OFF the appliance and allow to
cool down.
Quick-action operation: Fig. B
• Press switch-on safety device ( 1. ), then
• press ON button until the power tool starts
running (
2. ). Switch-on safety device can
now be released ( 3. ).
• To stop the appliance, release the
ON switch.
Continuous operation Fig. C
• Press switch-on safety device ( 1. ), then
• Press ON button ( 2. ).
Release both buttons ( 3. ).
• To stop the appliance, press the ON switch
again and release.
Slicing
Fig. A
• Gently press the food which is to be sliced
against the stop plate and slowly slide
against the moving blade.
After using the appliance
• Set the slicing width to 0 .
• Slide the carriage towards the blade into
the end position and lock with the slide (6)
in Pos. 1 .
After slicing greasy food (e.g. meat, sausage,
cheese):
• The appliance and especially the blade
should be cleaned immediately;
see “Cleaning” chapter.
Cleaning
/f\ Risk of injury from the sharp biade
Before cleaning the appliance, pull out the
mains plug and remove the blade.
Do NOT grip the blade by the cutting surface,
but by the blade attachment.
/f\
Eiectric shock risk
NEVER immerse the appliance in water
or place under running water.
5