Desa SVYD18PRA - Manual (Page 16)

www.desatech.com 113084-01E 16
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP SET
TEMP
AUTO
ON
OFF
REMOTE
O
FF
P ILOT
LO
IH
O
N
OPERATING HEATER
Continued
MANUAL LIGHTING
PROcEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 15.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions, page 15.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
27). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 14.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Slide the selector switch to
the REMOTE position (see Figure 22). Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 23).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 22 - Setting the Remote Selector
Switch, Control Knob and Flame
Adjustment Knob for Remote Operation
Remote Selector Switch
in REMOTE Position
(Optional Remote Control)
Flame Adjustment Knob
Control Knob
in ON Position
THERMOSTAT SERIES (MODEL
GHRcTB)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 24). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
Figure 23 - On/Off Hand-Held Remote
Control Unit (HR100)
Control Button
Turns Burners
On and Off
Figure 24 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Selects
Auto
Setting
Decreases Room
Temperature in
AUTO Mode
Increases
Room
Temperature
in AUTO
Mode
Locks
System to
Prevent
Accidental
Ignition
Digital Display Shows
Temperature and Settings
Turns
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Turns
Burners
On or Off