Admiral AW-05CR1FHLU - Manual (Page 13)

Operating Instructions /
► Control Panel
You can easily operate this air conditioner by press relevant
button on the control panel as well as the remote control.
ON/OFF
The air conditioner will be started when it is energized or will
be stopped when It is in operation, if you press this button.
MODE
Each time Mode button is pressed, the operation mode is
changed in sequence:
COOLING-FAN ONLY-ENERGY SAVING -COOLING
NOTE: After setting the mode, allow 3 minutes before
switching to another mode.
In the FAN ONLY Mode, Room Temperature display range
is from 0V(32T) to 38V(99r).
Room Temperature below OXi,the Temperature display LO.
Room Temperature above 38‘C,the Temperature display HI.
FAN SPEED
Used to select fan speed in sequence AUTO,LOW,MEDIUM
and HIGH.
Control Panel
TIMER (this button is not available on the control panel)
Used to set or cancel timer operation.
When the unit is in operation, you can set OFF TIMER.
When the unit is off, you can set ON TIMER.Timer setting
range is 0 to 24 hours.
If the OFF TIMER is set. the timer LED displays the
remaining time to turn off the unit for only 12 seconds, then
LED shifts to display set temperature. If you press TIMER
button within the 12 seconds.OFF TIMER will be canceled.
If the ON TIMER is set, the timer LED displays the
remaining time to turn on the unit. If you want to cancel
ON TIMER, press TIMER button.
A ▼
Used to set room temperature in COOLING mode or used
to set time in TIMER mode.
If the two keys are pressed at the same time .the
temperature LED display will alternate between *0 and T.
But the mark of "X:"or"T’’you can not change. Usually,
those models used 220V''/50Hz marked with "C". other
models marked with "T".
NOTE: Temperature setting range is from 19V(66T) to
3lV(88r).
И
Indication symbols of LED on control panel
Cooling ^ Auto fan speed
as
HR
Л Fan only 1^ Low ^n speed
Display set temp
Display set timer
о Energy-saving v Medium speed
Ф Timer ^ Hign fan speed
Above LED lights on when the relevant mode is In used.