NewAir ACP-1000E - Manual (Page 6)

Operation instructions
Setting the timer function:
Whiie the unit is operating, press the Timer button. You will enter the time that
you wish the unit to shut down. Then you will have the option of setting the time
for the air conditioner to resume function (from half an hour to 12 hours, in half
hour increments) or exiting the timer function.
► While the unit is in standby mode, you can also press the Timer button to set the
operation times. You will begin by entering the time at which you want the air
conditionerto begin working, and then you will be able to program the time at
which you want the unittogoback into standby mode (from half an hour to 12
hours, in half hou r increments) or exit the timer function.
Note: While in the set timeframe, the air conditioner will display a countdown
of the time remaining until the next mode is initiated.
► Adjusting the Airflow:
To havethe airflow oscillate from celling to floor, press the oscillation button
on the remote control. Right to left airflow is adjusted by manual adjusting
the louvers.
3, Operation instructions
Battery Installation:
I.Open the battery compartment by sliding down the battery cover
panel.
2. Remove and discard old batteries, replace with new batteries
3. Put the battery cover panel back in place.
ro
n)
c
«
ro
o
o
GO
• •
GO
h-‘
Tl
X
Tl
X
CO
m
73
C_i
m
■n
X
X
Note:
when turn off the unit, VFD indicator appear OF , till the sweep shut down.
Notes;
1 -The polarity of the batteries must match the indicator in the remote
controller
2.Please don't mix new and old batteries in the remote controller
3 .To prevent corrosion, remove the batteries if the controller will not be
used over a lengthy period
1 0
TJ
GO