Directed Audio 600/4 User Manual

Page 8

1. SSppeeaakkeerr OOuutt TTeerrm

miinnaallss - Connect

the speakers to these terminals.
(Refer to the

Speaker Connection

section of this guide.)

2. PPoow

weerr FFuusseess -- These fuse(s) protect

the amplifier against internal elec-
trical damage and are meant to
protect the amplifier only. All other
power connections should be fused
at the source.

3. ((++)) 1122 VVoolltt PPoow

weerr - Connect this

terminal through a FUSE or CIRCUIT
BREAKER to the positive terminal of
the vehicle battery or the positive
terminal of an isolated audio
system battery.

WAARRNNIINNGG:: Always protect this power wire by installing a fuse

or circuit breaker of the appropriate size within
12 inches of the battery terminal connection.

REAR PANEL CONNECTIONS

1. RRCCAA IInnppuutt JJaacckkss -- Accepts line level

outputs from head units or signal
processors at voltages between
150mV and 8 volts.

2. RRCCAA OOuuttppuutt JJaacckkss -- These pass

through RCA jacks can be used to
send a signal to a second amplifier.
They are the summed stereo output
of the one through four channel

inputs of the amplifier.

3. SSttaattuuss LLEEDD - Lights GREEN to indi-

cate the amplifier is on and oper-
ating normally and will be off if the
amplifier shuts down due to short
circuit, DC offset, or overheating
detected by the on-board protection
circuitry.

FRONT PANEL CONNECTIONS/STATUS LED

FRONT

REAR

OUTPUT

POWER

FIGURE 1—AMPLIFIER CONNECTIONS 600/4 FRONT