Chánging reversible doors – Avanti 1092 YWT User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chánging Reversible Doors:

This refrigerator has been built with the door hinges on the right. If you wish to change the

opening direction, follow instructions below.

1- Remove the upper rounded top (3). Using a sharp object, pry out the 2 plug buttons (1) and

remove the (2) PHILLIPS screws (1). Remove the 2 PHILLIPS screw (2) which connect the
upper hinges to the upper rounded top. Place top plate (3) on a padded surface to prevent

scratching.

2- Remove the hex-head screws of the upper hinge (4). Carefully lift the freezer door (5) and
place it on a padded surface to prevent scratching.

3- Remove the PHILLIPS screws of the center hinge (6). Carefully lift the door (7) and place it

on a padded surface to prevent scratching. Save the parts removed for future use.

4- Remove the kick plate (grille base) (8) by taking out the screws at each side of it with a

PHILLIPS screwdriver.

5- Remove the lower hinge (9) from the right side and transfer It to the left end.

6- Usfng a sharp object, pry out the plug buttons of the middle hinge holes (10). Press them into
the opposite comer (11),

7- Fit the grille base (12) into its place.

8- Set the lower door (13) to its place making sure the hinge pin enters the bushing in the door
bottom section.

9- While holding the door in the closed position, loosely secure the center hinge (14) using the
screw removed (STEP 3)

10- Set the freezer door (15) to its place making sure the hinge pin enters the door bushing in

the bottom sections of the door.

11 -While holding the freezer door in the closed position, loosely secure the upper hinge (16)

using the bolts removed in STEP 2.

12- Before tightening these bolts, make sure the top of the door is level with the cabinet top, and

the space between the doors is equidistant across the entire front. Avoid over-tightening these
screws. Tighten both until they are just snug, then turn them another one-half turn.

13- Replace the upper rounded top (17).

14- Tighten the upper rounded top screws (18) and press the plug buttons (18).

15- Fit and lighten the screws (19) which connect the upper hinges to the upper rounded top.